Handset Description; Acoustic Signal Confirmation; Commissioning; Performing Reset - VITRA CDS Mode D'emploi

Handset description

Save position buttons 1 – 4
Save button

Acoustic signal confirmation

As soon as the control system is supplied with power, you
will be alerted by an acoustic signal.
Overview of the acoustic signals (click):
2x = Normal mode
1x = Emergency mode
3x – 6x = Last shut-down not completed

Commissioning

After connecting to the power supply network, the table is
ready for operation.
If a fault occurs, a reset must be performed.
Up button
Display Down button

Performing reset

1. Lower the table to the bottom position.
To do this, press and hold the "Down" button until all the
drives have reached the bottom position.
2. Then press and hold the "Down" button again (for ap-
prox. 5 sec.) until the table has made a slight movement
down and then back up again.
Release the button as soon as the table no longer moves.
If the "Down" button is released before the reset has been
carried out, the reset is interrupted and you must repeat the
procedure.
! DANGER!
With all reset procedures and the end
position alignment, the anti-collision protection (ISP) is not
active. Pay attention to any potential crushing hazard!

Height adjustment

To move your table, press and hold the «up» or «down» button.
EN
21