Aligning The Appliance - Siemens iQ700 KF86N Série Notice De Montage Et D'utilisation

Aligning the appliance

Place the appliance vertically on a firm, level base.
1.
If the base is uneven, adjust the two screw feet at the
2.
front with a spanner.
To align, use a spirit level.
Note:
Align refrigerator compartment doors
Align the vertical gap between the refrigerator
compartment doors:
Remove door load.
1.
Remove the screw and cap on the bearing bracket.
2.
Release the safety screw.
3.
Caution!
Do not remove the safety screw.
Turn the adjustment screw until the desired position
4.
is reached when the door is closed.
– To move the upper end of the door outwards, turn
clockwise.
– To move the upper end of the door inwards, turn
anticlockwise.
Open and close the doors to check the position and
5.
correct if necessary.
Tighten the safety screw again.
6.
Fit the cap and tighten the screw again.
7.
Installation and connection
Align the horizontal gap between the refrigerator
compartment doors:
Open the refrigerator compartment door and the
1.
cool-fresh compartment.
Remove door load.
2.
Lift the door and insert a screwdriver into the bearing
3.
bracket from below.
Push up adjustable part and turn through 60 ° until
4.
the desired position is reached.
– The door height can be set at 2 levels, adjusted
by 1/16" (1.5 mm) in each case. The higher level
is followed by the lower. The adjustable part
engages as soon as a position is reached.
– To move the door up, turn clockwise.
– To move the door down, turn anticlockwise.
Close the refrigerator compartment door and the
5.
cool-fresh compartment to check the position and
correct if necessary.
If the door pillar at the top collides with the
Note:
housing, move the right-hand refrigerator compart-
ment door down.
en
31