Installing The Spacers; Installation Dimensions And Door Opening Angle; Fixing The Handle; Aligning The Appliance - Siemens KA N Série Notice De Montage Et D'utilisation

en

Installing the spacers

Remove two screws with screwdriver first, and take out
the spacers from plastic bag and fix it to the back of
the appliance through the screws then. This ensures
that there is a minimum distance between the appli­
ance and the wall.
Installation dimensions and door opening
angle
W2
D
130°
W W1
908 mm 418 mm

Fixing the handle

Before you use the product, please check the handle
of the refrigerator. If the handle is loose, you should
fix it with the hexangular screwdriver in the clockwise
direction, then it can be used normally.
24
W
W1
135°
W2 D
277 mm 628 mm 1171 mm

Aligning the appliance

To ensure that the appliance functions correctly, it must
be set level with a spirit level.
For sufficient leveling and air circulating in the lower
Ø
rear section of the appliance, the bottom feet may
need to be adjusted.
To allow the doors to self­close, tilt back the top
Ø
backwards at about 15 mm or 0.5° by turning the
adjustable feet.
Whenever you want to move the appliance,
Ø
remember to turn the feet back up, so that the
appliance can roll freely.
The rollers, which are not castors, should be only
Ø
used for forward or backward movement. Moving
the refrigerator sideways may damage your floor
and the rollers.
Reinstall the appliance when relocating.
Ø
D1
D1
0.5°
adjustable bottom feet