Festool ETS 150/3 EQ Notice D'utilisation D'origine page 11

Eccentric sander
Technical data
Wattage
Speed (220 - 240 V)
Speed (110 V, 120 V)
Sanding stroke
Sanding base
Weight according to EPTA-Procedure 01:2014
The specifi ed illustrations can be found at the beginning of the operating instructions.
Symbols
Warning of general danger
Risk of electric shock
Wear a dust mask!
Wear protective goggles!
Read the Operating Instructions/Notes!
Do not throw in the household waste!
Protection class II
1 Safety instructions
WARNING!
instructions, illustrations and specifications
provided with this power tool. Failure to follow
all instructions listed below may result in electric
shock, fi re and/or serious injury.
Save all warnings and instructions for future
reference.
The term „power tool" in the warnings refers
to your mains-operated (corded) power tool or
battery-operated (cordless) power tool.
Always wear protective goggles because
of possible dangers when sanding.
The manufacturer's handling and processing
instructions must be observed without fail if ex-
plosive or self-igniting dusts are likely to occur
during sanding.
Harmful/toxic dusts can occur during your work
(e.g. lead-containing paint, some types of wood).
Contact with these dusts, especially inhaling
them, can represent a hazard for operating per-
sonnel or persons in the vicinity. Comply with
the safety regulations that apply in your country.
Read all safety warnings,
ETS 150/3 EQ
ETS 150/3 E
310 W
4000 - 10000 rpm
6000 - 10,500 rpm
3.0 mm
Ø 150 mm
1.8 kg
Connect the electric power tool to a suitable ex-
traction system.
To protect your health, wear a P2 protec-
tive mask.
- Only for AS/NZS: The tool shall always be sup-
plied via residual current device with a rated
residual current of 30 mA or less.
- If the power tool is dropped or falls, check
for damage to the machine and sanding pad.
Remove the sanding pad for closer inspection.
Repair damaged parts before using again. Bro-
ken sanding pads and damaged machines can
cause injuries and machine instability.
2 Correct usage
The sanders are designed for sanding wood, plas-
tic, composite materials, paint / varnish, fi lling
material and similar materials.
Metal and materials with an asbestos content
must not be processed with these tools.
The user bears sole responsibility for
any damage or accidents resulting from
incorrect use.
3 Noise and vibration information
Typically, the noise levels that are determined in
accordance with EN 62841 (see EC declaration of
conformity) are as follows:
Sound pressure level
Sound-power level
Measuring uncertainty allowance
Vibration emission value a
directions) and uncertainty K measured in ac-
cordance with EN 62841 (see EU Declaration of
Conformity):
Vibration emission level
(3 directions)
Uncertainty
The specifi ed emissions values (vibration, noise)
– are used to compare machines.
11
ETS 150/5 EQ
ETS 150/5 E
310 W
4000 - 10000 rpm
6000 - 10500 rpm
5.0 mm
Ø 150 mm
1.8 kg
72 dB(A)
83 dB(A)
K = 3 dB
(vector sum for three
h
a = 4.7 m/s
h
K = 1.5 m/s
2
2