Operation - Cameo ROOT PAR TW Manuel D'utilisation

OPERATION

NOTES
• As soon as the spotlight is correctly connected to the power supply, "Welcome to Cameo", the model designation, and then the software
version are displayed in sequence on the display as part of the startup process. The spotlight is ready for use after this process, and the
previously selected mode will activate.
• Hold down the MODE button for approx. two seconds to directly access the main display from the lower menu levels. If there is no input
within approx. two minutes, the main display is automatically activated. Briefly press MODE to go up one level in the submenus.
• Briefly hold down MODE and ENTER at the same time to directly access the last menu option used from the main display.
• Starting from the main display, briefly press UP to rotate the display 180°.
• Press and hold UP or DOWN to quickly change a value (e.g., DMX start address).
MAIN DISPLAY DMX MODE
The DMX Address and the currently configured DMX start address (e.g., 001) are shown on the display. If the DMX Delay function is
activated, the delay group and the delay time are also displayed.
MAIN DISPLAY STAND-ALONE MODE
The currently activated stand-alone mode is shown on the display (Mode Direct, Mode CCT, Mode Loop, Mode Sound).
MAIN DISPLAY SLAVE MODE
Mode Slave is shown on the display. If the slave unit is assigned to a slave group, the slave group and delay time set on the master unit in
the stand-alone mode Loop are also displayed.
CONFIGURING THE DMX START ADDRESS
Starting from the main display, press MODE to go to the main menu. Using UP and DOWN, now select the DMX Address menu option and
press ENTER to confirm your selection. You can now set the DMX start address as desired using UP and DOWN. Select ENTER to confirm
your entry.
SETTING DMX MODE
Starting from the main display, press MODE to go to the main menu. Using UP and DOWN, now select the DMX Mode menu option and
press ENTER to confirm your selection. Use UP and DOWN again to select the desired DMX mode and press ENTER to confirm your selection.
You can find tables on channel assignment in the different DMX modes in these instructions under DMX CONTROL.
7