Operation - Cameo H2 FC Manuel D'utilisation

DMX OUT
4
Female 5-pin XLR socket for sending the DMX control signal.
OLED DISPLAY
5
The OLED display shows the currently activated mode (main display 1), the spotlight status (main display 2 = W-DMX status), the menu
items in the editing menu and the numerical value or operational status in certain menu items. Switch between both main displays by briefly
pressing ENTER and DOWN at the same time. Note on the main display in DMX operating mode: As soon as the control signal is interrupted,
the characters in the display begin to flash. When there is a control signal again, the flashing stops. Briefly pressing UP on the control panel
when in the main display rotates the display by 180°.
TOUCH-SENSITIVE CONTROLS
6
MENU – Press MENU to access the editing menu. Press repeatedly to return to the main display. Pressing MENU without confirming a value
or status change with ENTER restores the previously confirmed value or status.
ENTER – Press ENTER to access the menu levels to make value changes and use the ENTER control field to access the submenus. Confirm
value or status changes by pressing ENTER.
UP and DOWN – Select individual menu items in the selection menu (DMX address, operating mode etc.) and in the submenus. Allow
changes to the value in a menu item, such as the DMX address, as required.
Before changing device settings, ensure that the control panel is dry and clean, in order not to impair its functionality.
FUSE
7
Fuse holder for 5 x 20 mm micro fuses.
IMPORTANT: Replace the fuse only with a fuse of the same type and value. In the event of repeated fuse failure, please contact an authori-
sed service centre.
SECURING LUG
8
Securing lug for attaching the spotlight on truss installations and for fixed suspended ceiling installation.
9 ANTENNA
Antenna for wireless control via W-DMX.
10 CONNECTION TERMINAL
The connection terminal is used for voltage and signal supply for fixed installations. Observe the safety instructions for wiring the terminal
under CABLING THE TERMINAL.

OPERATION

PLEASE NOTE
• Immediately after connecting to the mains, the spotlight is ready for operation and the previously selected operating mode is activated.
• To navigate one level up in the menu structure, briefly press MENU, or press MENU again to return to the main display. The main display is
activated automatically if no input is made within approximately 30 seconds.
• Briefly pressing the UP button when in the main display rotates the display by 180°.
• To quickly change a value (e.g. DMX start address), press and hold the UP or DOWN button.
MAIN DISPLAY 1 DMX OPERATING MODE
The display shows the DMX address and current DMX start address (in the example001).
DMX Address
001
MAIN DISPLAY 1 STANDALONE MODE
The display shows the currently activated stand-alone mode.
Mode
Static
6
Mode Mode
Auto User Color
Mode
Tuneable White Color Macro
Mode