Connections, Operating And Display Elements; Operation - Cameo CLTW600UV Manuel D'utilisation

CONNECTIONS, OPERATING AND DISPLAY ELEMENTS

6
4
5
1
POWER IN
IEC mains socket with built-in fuse holder. A suitable IEC power cable is included.
IMPORTANT: Replace the fuse only with a fuse of the same type and value. In the event of repeated fuse failure, please contact an author-
ised service centre.
2
DMX IN
Male 3-pin XLR socket for connection to a DMX control device (e.g. DMX console).
3
DMX OUT
Female 3-pin XLR socket for sending the DMX control signal.
4 LED DISPLAY
The four-digit LED display shows the operating mode and other system information.
5
CONTROL BUTTONS
MODE: Select the different operating modes and the menu item DMX start address.
ENTER: Press ENTER to make value changes in the various menu items. Confirm value changes by pressing ENTER.
UP and DOWN: Use these buttons to alter the value of a menu item as required, e.g. DMX address.
6
MIC
Microphone for music-control mode.

OPERATION

• A short time after the light has been connected correctly to the mains, the spotlight is ready for operation and starts in the previously
enabled mode.
• The display turns off about 15 seconds after the last entry via the buttons. A small red dot appears at the bottom of the display at the
same time. In DMX mode, the dot begins to flash when a control signal is present. It stops flashing if the control signal is interrupted.
DMX MODE SELECTION
Press the MODE button until one of the available DMX modes is shown in the display and press ENTER. Use the UP/DOWN buttons to select
the desired DMX mode and confirm the entry with ENTER (1-channel 1, 1-channel 2, 2-channel, 4-channel).
Tables with the channel assignment of the different DMX modes can be found in these instructions under DMX CONTROL.
ENTER
/
UP/DOWN
/ /
2
ENTER
3
1
5