Sony SNC-RX550N Manuel D'installation page 37

Owner's Record
The model and serial numbers are located on
the bottom. Record these numbers in the
spaces provided below.
Refer to these numbers whenever you call
upon your Sony dealer regarding this
product.
Model No.
WARNING
To reduce a risk of fire or electric
shock, do not expose this product to
rain or moisture.
To avoid electrical shock, do not
open the cabinet. Refer servicing to
qualified personnel only.
WARNING
This installation should be made by a
qualified service person and should conform
to all local codes.
WARNING
A readily accessible disconnect device shall
be incorporated in the building installation
wiring.
WARNING (for Installers only)
Instructions for installing the equipment on
the ceiling:
After the installation, ensure the connection
is capable of supporting five times the
weight of the equipment downwards.
CAUTION
The rating label is located on the bottom.
CAUTION for LAN port
For safety reason, do not connect the LAN
port to any network devices that might have
excessive voltage.
Power Supply
Caution for U.S.A. and Canada
The SNC-RX550N operates on 24V AC or
12V DC.
The SNC-RX550N automatically detects the
power.
Serial No.
Use a Class 2 power supply which is UL
Listed (in the U.S.A) or CSA-certified (in
Canada)
Caution for other countries
The SNC-RX550N/RX550P operates on
24V AC or 12V DC.
The SNC-RX550N/RX550P automatically
detects the power.
Use a power supply rated 24 V AC or 12 V
DC which meets the requirements for SELV
(Safety Extra Low Voltage) and complies
with Limited Power Source according to
IEC 60950.
For customers in the U.S.A. (SNC-
RX550N only)
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and (2)
this device must accept any interference
received, including interference that may
cause undesired operation.
NOTE: This equipment has been tested and
found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference when the equipment is operated
in a commercial environment. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed
and used in accordance with the instruction
manual, may cause harmful interference to
radio communications. Operation of this
equipment in a residential area is likely to
cause harmful interference in which case the
user will be required to correct the
interference at his own expense.
You are cautioned that any changes or
modifications not expressly approved in this
manual could void your authority to operate
this equipment.
All interface cables used to connect
peripherals must be shielded in order to
comply with the limits for a digital device
pursuant to Subpart B or Part 15 of FCC
Rules.
GB
1
GB