Maxspect GLAIVE Mode D'emploi page 9

Using the Basic Controller
1. Turn on / off the fixture
Press and hold the control dial for 5 seconds to turn on / off the fixture.
2. Manually adjusting the intensity of each channel
When the fixture is turned on, press the control dial once to enter Manual
Adjustment Mode.
The first channel A (indicator light yellow) will become adjustable. Rotate the control
dial to adjust the intensity. Press the control dial again to switch to channel B (indicator
light blue), and so on. The setting will be saved after 10 seconds of idling.
The speed at which the indicator LED light blinks indicates its intensity. If the indicator
LED light does not blink, the channel is at 100% intensity. If the indicator LED light
blinks at 1s interval, the channel is at 0% intensity (turned off).
Please refer to the following table to see the color of the indicator LED light and its
corresponding channel.
Channel A
Indicator LED
Light Color
G4-F Models
Cool White
G4-M Models
Warm White
3. Switching to Demonstration Mode
When the fixture is turned on, press and hold the control dial for 2 seconds to enter
Demonstration Mode.
The fixture will slowly turn on each channel to 100% one after the other when
Demonstration Mode has been set. Press and hold the control dial for 2 seconds to
exit this mode.
Channel B
Yellow Blue
6000K 450nm
Blue
3000K 460nm
Royal Blue
Operating Instructions
Channel C
Green
520nm
Green
500nm
Cyan
English
Channel D
Red
620nm
Red
420nm
Super Actinic
8