Mounting The Drive Tube; Mounting The Loop Handle - Stihl HLE 71 Notice D'emploi

Mounting the Drive Tube

2
3
A
Pull the protective cap off the drive
N
tube.
Push the drive tube (1) into the
N
motor housing (2) as far as the mark
(A), turning the drive tube back and
forth at the same time.
Tighten down the screw (3) in the
N
housing firmly.
HLE 71, HLE 71K

Mounting the Loop Handle

1
3
A
Place the clamp (1) in the loop
N
handle (2) and position them both
against the drive tube (5) between
the carrying ring (3) and handle
hose (4).
Place the clamp (6) against the
N
drive tube.
Line up the holes.
N
Insert the screws (7) with
N
washers (8).
Fit the square nuts (9) and screw
N
home the screws.
7
7
8
8
2
1
6
9
N
9
Distance (A) must not be more than
45 cm. Recommendation: about 35 cm.
N
A
2
Align the loop handle (2) and move
it to the most comfortable position.
Tighten down the screws firmly.
English
33