Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
SPECIFICATIONS
Capacities
No load speed (RPM)
Blows per minute
Standard battery cartridges
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
GENERAL SAFETY RULES
WARNING! Read all instructions. Failure to follow all
instructions listed below may result in electric shock, fire
and/or serious injury. The term "power tool" in all of the
warnings listed below refers to your mains-operated
(corded) power tool or battery-operated (cordless) power
tool.
SAVE THESE INSTRUCTIONS.
Work area safety
1.
Keep work area clean and well lit. Cluttered and
dark areas invite accidents.
2.
Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases or dust. Power tools
create sparks which may ignite the dust or fumes.
3.
Keep children and bystanders away while
operating a power tool. Distractions can cause
you to lose control.
Electrical Safety
4.
Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any
adapter plugs with earthed (grounded) power
tools. Unmodified plugs and matching outlets will
reduce risk of electric shock.
5.
Avoid body contact with earthed or grounded
surfaces such as pipes, radiators, ranges and
refrigerators. There is an increased risk of
electric shock if your body is earthed or grounded.
6.
Do not expose power tools to rain or wet
conditions. Water entering a power tool will
Model
Concrete
Steel
Wood
Wood screw
Machine screw
High (2)
Low (1)
High (2)
Low (1)
Overall length
Net weight
Rated voltage
BHP343
10 mm (3/8")
10 mm (3/8")
25 mm (1")
5.1 x 63 mm (13/64" x 2-1/2")
211 mm (8 - 5/16")
1.4 Kg (3.1lbs)
D.C. 14.4 V
BL1415
GEA002-3
increase the risk of electric shock.
7.
Do not abuse the cord. Never use the cord for
carrying, pulling or unplugging the power tool.
Keep cord away from heat, oil, sharp edges or
moving parts. Damaged or entangled cords
increase the risk of electric shock.
8.
When operating a power tool outdoors, use an
extension cord suitable for outdoor use. Use of
a cord suitable for outdoor use reduces the risk of
electric shock.
Personal Safety
9.
Stay alert, watch what you are doing and use
common sense when operating a power tool.
Do not use a power tool while you are tired or
under the influence of drugs, alcohol or
medication. A moment of inattention while
operating power tools may result in serious
personal injury.
10. Use safety equipment. Always wear eye
protection. Safety equipment such as dust mask,
non-skid safety shoes, hard hat, or hearing
protection used for appropriate conditions will
reduce personal injuries.
11.
Avoid accidental starting. Ensure the switch is
in the off-position before plugging in. Carrying
power tools with your finger on the switch or
plugging in power tools that have the switch on
invites accidents.
12. Remove any adjusting key or wrench before
turning the power tool on. A wrench or a key left
attached to a rotating part of the power tool may
result in personal injury.
13. Do not overreach. Keep proper footing and
balance at all times. This enables better control
2
BHP453
13 mm (1/2")
13 mm (1/2")
36 mm (1-7/16")
6 mm x 75 mm (1/4" x 2-15/16")
6 mm (1/4")
0- 1,300 /min.
0 - 400 /min.
0 - 19,500
0 - 6,000
240 mm (9-7/16")
1.7 Kg (3.7lbs)
D.C. 18 V
BL1815
Publicité
Table des Matières
