General Safety Rules; Work Area Safety; Electrical Safety - Makita BTP130 Manuel D'instruction

ENGLISH
SPECIFICATIONS
Impact driver mode
Hammer drill mode
Drill mode
Screw driver mode
• Due to our continuing programme of research and development, the specifications herein are subject to change
without notice.
• Note: Specifications may differ from country to country.

GENERAL SAFETY RULES

WARNING:
Read all instructions. Failure to follow all
instructions listed below may result in elec-
tric shock, fire and/or serious injury. The
term "power tool" in all of the warnings listed
below refers to
(corded) power tool or battery-operated
(cordless) power tool.
SAVE THESE INSTRUCTIONS

Work area safety

1. Keep work area clean and well lit. Cluttered and
dark areas invite accidents.
Model
Max. fastening torque
Capacities
No load speed (RPM)
Impacts per minute
No load speed (RPM)
Blows per minute
Capacities
No load speed (RPM)
Capacities
No load speed (RPM)
Capacities
Overall length
Net weight
Rated voltage
Standard battery cartridge
GEA002-3
your mains-operated
135 N•m (100 ft.lbs)
Machine screw
Standard bolt
High tensile bolt
Concrete
High (2)
Low (1)
Steel
Wood
Machine screw
2. Do not operate power tools in explosive atmo-
spheres, such as in the presence of flammable
liquids, gases or dust. Power tools create sparks
which may ignite the dust or fumes.
3. Keep children and bystanders away while oper-
ating a power tool. Distractions can cause you to
lose control.

Electrical safety

4. Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any
adapter plugs with earthed (grounded) power
tools. Unmodified plugs and matching outlets will
reduce risk of electric shock.
5. Avoid body contact with earthed or grounded
surfaces such as pipes, radiators, ranges and
refrigerators. There is an increased risk of electric
shock if your body is earthed or grounded.
6. Do not expose power tools to rain or wet condi-
tions. Water entering a power tool will increase the
risk of electric shock.
2
BTP130
145 N•m (107 ft.lbs)
4 mm - 8 mm (5/32" - 5/16")
5 mm - 14 mm (3/16" - 9/16")
5 mm - 12 mm (3/16" - 1/2")
0 - 2,400/min.
0 - 3,200
0 - 2,400/min.
0 - 28,800/min.
8 mm (5/16")
0 -2,400
0 - 700/min.
10 mm (3/8")
21 mm (13/16")
0 - 2,400/min.
M4
186 mm (7-3/8")
1.7 kg ( 3.7 lbs)
D.C.14.4 V
BL1430
BTP140
0 - 2,300/min.
0 - 2,300/min.
0 - 27,600/min.
0 -2,300
0 - 2,300/min.
1.8 kg ( 4.0 lbs)
D.C.18 V
BL1830