Light Intensity - Philips HF3419 Mode D'emploi

ENGLISH
10
Travelling east
When you travel east , you have to advance your sleep time by a number of hours that equals the
time zones you cross. You can shift your body clock forwards in steps of one hour a day. The number
of time zones you cross determines how many days before departure you have to start using the
Philips EnergyUp. Use the appliance for 30 minutes after you wake up. Avoid bright light in the
evening and go to bed early. When you arrive at your destination, avoid bright light during your
normal sleep period. Expose yourself to bright light at the end of this period to advance your body
clock further to the local time.
Before your return light, use the Philips EnergyUp late in the evening for a couple of days.
On the last night of the trip, try to stay up and use the appliance as late as possible after midnight.
On the day of the light, avoid any bright light in the morning.
Travelling west
Since most people's body clocks adjust more easily to later time zones, you only have to use the
Philips EnergyUp for one day before you travel across four time zones. Add an additional
preparation day for each three additional time zones. You do not have to use the Philips EnergyUp
for more than three days, even on longer westbound trips. Use the appliance for 30–40 minutes late
in the evening. Start two or three days before you leave. Use the appliance two hours later the
following nights.
When you arrive at your destination, try to stay awake until bedtime and avoid bright evening light
(wear sunglasses) for the irst few days. Before you travel home, avoid any bright afternoon and
evening light. Use the Philips EnergyUp in the morning for a few days.

Light intensity

Use the Philips EnergyUp in addition to the normal room lighting. The Philips EnergyUp is more
comfortable to use in a well-lit room. Adjust the brightness to a comfortable level. Allow a few
minutes for your eyes to get used to the bright light. If the highest setting is too bright for you, start
using the appliance at a lower setting. Increase the light intensity if you feel no effect after a week.
How to use the appliance
1 Insert the small plug in the socket on the back of the appliance (Fig. 2).
2 Fold out the stand. To ensure the light reaches your eyes, this appliance has a stand that can
be set to a variable angle.
If you are sitting higher or standing and the top edge of the appliance is below eye level, place
-
the appliance in a tilted position so that its light points further upwards and reaches your
eyes (Fig. 3).
If you are sitting at a table or desk and the top edge of the appliance is above eye level,
-
you can place the appliance in a more upright position (Fig. 4).
You can also use the stand to hang the appliance on the wall (Fig. 5).
-
Note: To hang the appliance on a wall, drill two holes 100-120mm apart and insert two hooks with a
diameter of 4mm (Fig. 6).
3 Insert the adapter in a wall socket (Fig. 7)
4 Make sure that the appliance is positioned at arm's length (at approximately 50-75cm
from your eyes) within your ield of vision. The light must bathe your face (Fig. 8).
You can read, eat, work at the computer, watch TV or exercise while you use the appliance.
-
For the best results, place the appliance at the same level as your midriff (stomach area),
-
e.g. place it on the table at which you are sitting.
Make sure that the surroundings of the appliance are well-lit for more visual comfort.
-
Note: Do not stare into the light of the appliance. It is suficient that the bright light reaches your eyes indirectly.