Olympus Camedia C-3030ZOOM Mode D'emploi page 33

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Do not recharge alkaline or lithium batteries
• If you try to recharge them, it may cause the batteries to leak and/or the
camera to be damaged.
Do not use or store in a hot place (e.g. inside a closed car on a hot and
sunny day)
• If may shorten their service life. Store in a dry cool place protected from
direct sunlight.
Keep out of the reach of children
• Make sure children do not take the batteries out when using the camera. If a
child is going to use the camera, be sure to teach the child proper usage
according to this manual.
• When disposing of old batteries, be sure to do so in accordance with all
applicable regulations in your area.
Precautions on using accessories
• Be sure to use only the supplied accessories, or accessories recommended
by the manufacturer, otherwise fire, electric shock or damage may result.
For more information, please consult the dealer where the unit was
purchased.
• Do not keep the AC adaptor connected when not using the camera,
otherwise fire, electric shock or damage may result.
• To prevent electric shock and damage, do not plug, connect or handle the
AC adaptor with wet hands.
• Do not modify, bend forcibly, pull strongly, scratch, etc., or otherwise alter
the AC adaptor power cord. Also, do not put heavy objects on the power
cord, or place it close to a heat source as it may result in a fire or electric
shock.
Notes on display and backlight
• The Control panel and the fluorescent lamps used in the LCD monitor have
a limited service life. If they begin to darken or flicker, contact your nearest
service center.
• In cold conditions, the display backlight may be slow to come on or may
change color suddenly. To avoid this, keep the camera warm when using in
cold temperatures. Backlight performance will return to normal under normal
temperature conditions.
• When the color LCD monitor shows different pictures, some pixels may not
change color and remain on or off. This phenomenon may be due to a lag in
some circuits, but is considered to be within the normal operating tolerances
of the LCD monitor. In addition, the brightness of the color LCD monitor may
vary between pictures.
33

Publicité

Table des Matières
loading

Table des Matières