Westfire WF23 Notice D'installation Et D'utilisation page 21

FIRE BRICK INSTALLATION SEQUENCE – WESTFIRE UNIQ23
Vermiculite brick set for the UNIQ23 freestanding and UNIQ23 inset stove
Installation procedure:
1. Inner Top Turbulence Brick
2. Left Mid Baffle Brick
3. Right Mid Baffle Brick
4. Rear Brick
5. Left Base Brick
6. Left Side Brick
7. Right Base Brick
8. Right Side Brick
9. Outer Top Baffle Brick
10. Rear Base Brick
11. Front Base Brick
12. Grate Support
13. Grate
14. Log Retainer
Inner top turbulence brick 1 is positioned on
the secondary air pipe with angled edge at
rear, sloping down. Brick 1 is held in place
with a steel pin.
Inner top turbulence brick 1 is positioned on
the secondary air pipe with angled edge at
rear, sloping down. Brick 1 is held in place
with a steel pin.
Left & right mid baffle bricks 2 & 3
positioned with full angled edge at front
and part angled edge on the outside.
Bricks 2 & 3 need to be fitted lower down
and slid upwards into final position.
Rear brick 4 positioned lining up tertiary
air holes with angled edge sloping down
at rear.
Left base brick 5 positioned.
Left side brick 6 positioned on top of left
base brick 5. Left mid baffle brick 2 must be
held up to enable brick 6 to be fitted. Brick
2 is then supported by left side brick 6.
Right base brick 7 positioned.
WESTFIRE · WF23
1.
2. 3.
9.
4.
10.
6. 5. 7.
12., 13.
11.
14.
21
8.
Right side brick 8 positioned on top of
right base brick 7. Right mid baffle brick
3 must be held up to enable brick 8 to be
fitted. Brick 3 is then supported by right
side brick 8.
Outer top baffle brick 9 fitted with angled
edge at rear sloping down, resting
on rear brick 4 and supported by two
side pins.
Rear base brick 10 fitted.
Front base brick 11 fitted.
Grate support 12 fitted.
Grate 13 fitted.
Log retainer 14 fitted.
UK