Installing The Appliance - Westfire WF23 Notice D'installation Et D'utilisation

UK

INSTALLING THE APPLIANCE

I) Remove door and frame
a. Open door and lift so bottom hinge in lifts out of holder.
b. Tilt base away from stove and lower door.
c. Door should now be released.
d. Place door in a safe place.
II) Remove Frame from stove.
a. Once door is removed
b. Loosen four Allen keys and frame will come away.
c.
III) Remove Brick set
a. See manual below
IV) Remove Bar from flue collar
a. Loosen bolts holding flue collar
b. Remove flue collar taking care not to lose nuts and bolts.
V) Fit collar to stainless steel flue (we recommend a 500mm
section of 1mm stainless steel flue pipe if possible)
VI) Fill any Void with at the back and sides with a 6;1 vermiculite
to cement mix or any other good quality non-combustible
insulation material. It is important that the back and sides of
the stove are well insulated.
VII) Connect the stove to the flue
a. Pull stove collar to top of stove from inside the appliance.
b. Align bolt locations and re-bolt the spigot (and Flue) to stove.
c. Tighten bolts and secure.
VIII) Finish around stove
IX) Re-fit frame
a. If a newly plastered room please take care not to leave
painted frame and door fitted as the extremes of moisture
while the plaster dries and cause corrosion to the paint work.
b. Allow the plaster to dry before re-fitting door and frame.
Store in a dry and well ventilated place.
X) Re-fit door
XI) Re-fit brick as shown in the instructions in this booklet
WESTFIRE · WF23
To remove frame unscrew 2 nuts
from top and 2 nuts from bottom,
please remove door before
removed the stove frame.
12