Before Starting To Work - Hilti TE 75 Mode D'emploi

1
2
Pos.1
3
4 5
➡
6
Pos.2
Printed: 07.07.2013 | Doc-Nr: PUB / 5071192 / 000 / 00

Before starting to work:

1. Caution: When working with the tool, it must
be always held with both hands. Make sure that
you have a good foothold at all times. When drilling,
always use the side handle. Make sure the side
handle is correctly mounted and properly tight-
ened. Hold side handle at outermost end (fig. 6)
and stay alert. The drill bit can bind anytime.
2. Check that the electric supply is the same as
on the nameplate.
3. Don't press excessively on the tool. This
does not increase the hammering power. Simply
position and guide the tool.
Read the enclosed Safety Precautions.
Fig. 1: The connection end should be regularly
cleaned and lubricated sparingly with Hilti grease.
Shorten the start-up time in cold conditions by
jolting the drill bit, chisel etc. once briefly against
the work surface when switching on.
Operation:
Fig. 2: Insertion of TE-FY tool
Insert tool connection end into chuck as far as it
will go and turn until drive grooves engage and
tool can be pushed back fully. Pull back locking
sleeve (Pos. 1) and insert tool as far as it will
go. Release locking sleeve.
Remove insert tool by pulling back locking sleeve
(Pos.1), then pulling out insert tool.
Drilling:
Fig. 3: Rotary hammer drilling: Shift setting lever
to indicated rotary hammer
position (symbol ) to drill concrete,
masonry and natural stone.
Note: Before resetting from chiselling to rotary
hammer drilling, shift lever upwards to unlock
and only then set at rotary hammer drilling.
Rotary drilling only: Shift setting lever to indi-
cated rotary hammer drilling position (symbol
). By use of adaptor with keyless chuck or
setting tools for anchors, only the rotary action
is transmitted to the tool because of the shorter
connection end, namenly to:
Fig. 6: Side handle and depth gauge adjustment
Turn side handle loose, rotate to desired position,
tighten side handle again. For exact drilling depth
(e.g. drilling anchor holes), turn side handle loose,
set depth gauge (Pos. 2) to desired drilling depth,
tighten side handle again.
Chiselling:
Fig. 2: Insert chisel (same as with drill bits).
Fig. 3: Shift setting lever to middle position (sym-
bol 0). Chisel blade can be rotated to desired
working position. Shift setting lever to chiselling
position (symbol
Fig. 4: Beginning work
Hold chisel against work surface and press
electronic switch. Speed is infinitely variable.
Fig. 5: Select hammering power (symbol
100%; symbol 50%). Hold TE 75 firmly
against work surface and chisel.
Servicing:
Fig. 5: The TE 75 has a servicing indicator. If
the lamp lights up, carry out servicing. If this is
not done, costly damage can be caused.
drilling
Electric tools must comply with the respective
safety regulations. Servicing, therefore, must only
be carried out by a skilled electrician or electrical
specialist. The use of original Hilti components
will provide an optimum of safety.
).