User Manual - Velleman WS1080 Mode D'emploi

1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle
could harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal
waste; it should be taken to a specialized company for recycling. This device should be returned
to your distributor or to a local recycling service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Velleman! Please read the manual thoroughly before bringing this device into
service. If the device was damaged in transit, do not install or use it and contact your dealer. Damage
caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer
will not accept responsibility for any ensuing defects or problems.
2. Setting up the Stations
Refer to the illustrations on page 2 and following of this manual.
Weather station
1. Install your outdoor weather station on a suitable location minding the wind direction markings.
Connect the anemometer to the wind vane phone jacket.
2. Connect the wind vane to the thermo-hygrometer WIND phone jacket.
3. Connect the rain sensor to the thermo-hygrometer RAIN phone jacket.
4. Finally, insert 3 x AA batteries into the weather station respecting the polarity.
Receiver
1. Insert 2 x AA batteries into the receiver respecting the polarity.
2. Wait for the two stations to synchronize.
This synchronisation may take a couple of minutes. Do not touch the screen during synchronisation.
3. Once the synchronisation finished, make sure that all components work properly.
4. Choose a suitable mounting location for the receiver.
Commonly, the communication between the two stations can reach a distance of 100 m in the open
field, provided that there are no obstacles such as buildings, trees, vehicles, high-voltage lines, etc.
Radio interference such as from PCs, radios and television sets can entirely cut off the
communication. Take this into consideration when choosing a mounting location.
3. The Different Functions
Indoor Temperature
1. Touch the indoor temperature section once and press + or – to
switch between the temperature display in °C or °F.
2. Touch the indoor temperature section a second time and press
+ or – to set the high temperature alarm (HI AL), or press
ON/OFF to switch the alarm on or off.
3. Touch the indoor temperature section a third time and press +
or – to set the low temperature alarm (LO AL), or press ON/OFF
to switch the alarm on or off.
4. Touch the indoor temperature section a fourth time to display
the maximum temperature reading. Hold the value pressed to
reset the value.
5. Touch the indoor temperature section a fifth time to display the
minimum temperature reading. Hold the value pressed to reset
the value.
V. 15 – 08/11/2016
WS1080

USER MANUAL

4 ©Velleman nv