Vermeiren Liftchair Mode D'emploi page 4

EN
Usage of the buttons:
• 1 motor (legrest and backrest
moves together)
→ When the liftchair is not being used, leave it
the sitting position and not in the elevated posi-
tion.
• 2 motors (legrest and backrest
Backrest
inclination
1 = Backrest inclination forewards
2 = Backrest inclination backwards
3 = Lift function (stepless adjustment from
sit-position to lift-position: seat upwards +
legrest downwards)
4 = Lay function (stepless adjustment to
stretched position: seat downwards +
legrest upwards)
S FETY
→ Please do not exceed the maximum users
→ Be extremely careful in the presence of child-
weight of 150 kg.
LIFT FUNCTIONS
Stepless adjustment from
sit-position to lift-posi-
tion.
LAY BACK FUNCTION
Stepless adjustment to
stretched position
moves separate)
Tilting +
3
1
inclination
4
2
legrest
ren or pets.
→ Do not allow children to be under the chair,
use the chair or play with it because it might
→ If the wheelchair blocks in the lying position,
cause injuries when the legrest are folding.
you must ask assistance to leave the chair.
→ Please do not place the liftchair near any
heat source or type of electric radiator, fire-
place, radiator or radiator with flammable li-
quid because the coatings are not fire-resistant.
Never smoke when seated in the liftchair.
→ It is strongly recommended not to operate
the liftchair near a desk or a wall too close to
it, as not to cause damage by tilting the back
or the legrests.
→ If you need to retrieve a fallen object under-
neath the seat, disconnect the front to avoid get-
ting stuck.
→ For prolonged use of the liftchair motor
(about 2 min), you'll have to wait a few minutes
before reusing it. This is needed to avoid over-
heating the liftchair motor.
→ Do not move the liftchair:
• when the liftchair is in the lying position;
• when the liftchair is connected to the power
and/or in service.
→ Be careful not to sit on the armrests or on the
legrest.
→ Ensure that no cables become squeezed.
M INTEN NCE
→ Inspect your liftchair regularly to detect any
damage on the coating, framework or loose.