Eaton xChargeIn Manuel D'utilisation page 116

Authorization
Information
If RFID cards have previously been taught in, they will be deleted in the
course of the teaching-in procedure!
To teach in the RFID master card, proceed as follows:
1) Remove the housing cover and connection panel cover to access the
2) Hold the service button pressed in the connection panel until the second
3) Immediately after rebooting the charging station, an RFID master card
A successful teaching-in process is confirmed by a signal tone.
Information
After teaching in the RFID master card, the LED bar flashes green for a fur-
ther 60 seconds and a charging session authorized by the RFID master
card can be started. After this, the LED bar flashes blue to indicate that au-
thorization to start a charge is required.
5.2.3 Teaching in the slave card
The RFID slave card can be used to authorize a charging process. The
RFID master card is required to teach in an RFID slave card.
No charging session may be active for the teaching in and no vehicle may
be connected to the charging station. The LED bar must flash blue.
To teach in the RFID slave card, proceed as follows:
1) Hold the RFID master card in front of the RFID reader until a signal tone
2) Within 3 seconds hold the new RFID slave card to be taught in front of
3) Confirm the teach-in process within 3 seconds by holding the RFID mas-
The LED bar then flashes blue to indicate that authorization to start a charge
is required.
116
service button (see 5.2.1 Preparing the charging
signal tone sounds (approx. 10 seconds).
The charging station now performs a restart automatically.
must be taught in within 60 seconds by holding it in front of the RFID
reader.
sounds.
the RFID reader. A successful programming process is confirmed by a
rising tone sequence.
ter card in front of the RFID reader again. The procedure is concluded
by a further rising tone sequence.
xChargeIn
station).
Operating instructions V1.04
© EATON