Eaton xChargeIn Manuel D'utilisation page 113

xChargeIn
National approval
Calibratable energy meters with national approval also feature the following
displays:
Relevant displays are furnished with a special marking for the national ap-
proval:
Operating instructions V1.04
© EATON
Display
Sum of total transmitted energy
Display during start-up of the charging station as well as at the start
and after completion of a charging process
Displays of the firmware version
Display during start-up of the charging station and when starting a
charging process
1. "MID"
2. Firmware version
3. Build version
4. Checksum
On the left is an example of the firmware version 12.34.56.
If the display is marked with a preceding "M!", an internal message
was stored in the memory of the charging station during the charging
process. When restarting the charging station, the marking is reset.
MID-relevant error. The charging station must be returned for repair.
Display
Transmitted energy of the current charging process
Display during a charging process
Display
Firmware version
Display during start-up of the charging station and when starting a
charging process
The individual characters of the firmware version have the following
meaning: vX: Version X, #1A2B: Checksum
Transmitted energy of the current charging process
Display at start and after completion of a charging process
Identification data for the current charging process (e.g. serial num-
ber of the RFID card being used), for traceability of the transaction in
billing.
Display during the start of a charging process
The second part of the identification data is displayed, while the first
is replaced by an asterisk (*).
Displays and operating elements
Description
Description
Description
113