Beeper TPM101 Notice Technique page 32

5. USE OF THE PRODUCT
F. Resolution of the possible encountered problems
> Why does no pressure appear on the screen after the installation of the sensors?
Before to install the sensors, you have to initially connect the screen on your cigar-lighter. Thus, once the installation of the sensors is finished, the display will
receive the signal and show the values.
> Why does the value of the pressure on the screen change (in particular when I lead the morning)?
When the car is parked, the value of the pressure turns back in its previous state. Consequently, when the car starts, the system resets the value pressure. The
temperature and the pressure will increase after driving a few moments.
> Can the sensor fall during control or can be easily catch?
The sensors were especially designed to resist during the driving. Moreover, a special key is necessary to withdraw the sensors.
32