Beeper TPM101 Notice Technique page 30

5. USE OF THE PRODUCT
C. Detail of the features
> When you turn on your vehicle, the system goes in initialization mode and all the indicators light up.
> When the vehicle reaches 20 km/h, the sensors are activated and the values of pressure and temperature of the four tires will be displayed on the screen.
> When tire pressure is higher than the default alarm value or if there is an air leak, the indicator "
flash. At the same time, a beep ring. To stop the alarm, you just have to press any button. A beep will simply continue to ring each minute, until the pressure of the
tire is correct.
> When the temperature of the tire is higher than the default alert value, the indicator "
beep sound. To stop the alarm, you just have to press any button. A beep sound will simply continue to ring each minute, until the temperature goes back to its
normal conditions.
> When the battery of a sensor is weak, the indicator "
beep sounds. That means that you have to change the batery of the sensor.
> The pressure and temperature value are refreshed every 1 or 2 minute. If the display does not receive any signal of one or several sensor(s) in 40 minutes, the
power station gives 5 beeps and the value of the pressure of the tire does not appear anymore on the display. Moreover, if the vehicule is under 20 Km/h more
than 1 hour, the power station gives 5 beeps because there are no longer information sent by the sensors.
"and the temperature start to flash. At the same moment, there is a
C
H
"and the value of pressure of the sensor concerned start to flash. At the same moment, there are five
30
"and the pressure value of pressure of the tire, start to