Prior To Operation - Metabo HPT CJ 14DSL Instructions De Sécurité Et Mode D'emploi

English
CAUTION
● When the battery charger has been continuosly
used, the battery charger will be heated, thus
constituting the cause of the failures. Once the
charging has been completed, give 15 minutes
rest until the next charging.
● If the battery is rechraged when it is warm due
to battery use or exposure to sunlight, the pilot
lamp may light in green.
The battery will not be recharged. In such a case,
let the battery cool before charging.
● When the pilot lamp fl ikers rapidly in red (at
0.2–second intervals), check for and take out
any foreign objects in the charger's battery
installation hole. If there are no foreign objects,
it is probable that the battery or charger is
malfunctioning. Take it to your authorized
Service Center.

PRIOR TO OPERATION

1. Power switch
Ensure that the switch is in the OFF position.
2. Confi rming condition of the environment:
Confi rm that the work site is placed under appropriate
conditions conforming to prescribed precautions.
3. Dust produced in operation
The dust produced in normal operation may aff ect
the operator's health. Either of following way is
recommended.
a) Wear a dust mask
b) Use external dust collection equipment
When using the external dust collection equipment,
connect the adapter with the hose from external dust
collection equipment. (Fig. 5)
Notch
Base
Rear
hole
4. Changing blades
CAUTION
● Be sure to switch power OFF and disconnect the
battery from the body when changing blades.
● Do not open the lever when plunger is moving.
12
Hook
Cleaner
Dust
collector Adapter
Fig. 5
(1) Open the lever up to the stop. (Fig. 6-arrow I)
(2) Remove fi tted blade.
(3) Insert new blade up to the stop in the blade holder.
(Fig. 6-arrow II)
(4) Close the lever. (Fig. 6-arrow III)
NOTE
○ Confi rm the protrusions of blade inserted to the blade
holder surely. (Fig. 7)
○ Confi rm the blade located between the groove of
roller. (Fig. 8)
Blade
Blade holder
Blade
Roller
5. Switch operation
(1) Lock-off button (Fig. 9)
The jig saw is equipped with a lock-off button. To
activate the trigger lock, move the button to the lock
position. Move the button to the free position to
operate the tool.
Blade
Blade
holder
Lever
Fig. 6
Fig. 7
Blade
Roller
Fig. 8