Assembly And Operation; Applications; Prior To Operation - Metabo HPT CJ 90VST2 Instructions De Sécurité Et Mode D'emploi

English

APPLICATIONS

○ Cutting various lumber and pocket cutting
○ Cutting mild steel plate, aluminum plate, and copper
plate
○ Cutting plastics, such as phenol resin and vinyl
chloride
○ Cutting thin and soft construction materials
○ Cutting stainless steel plate (With No. 97 blade)

PRIOR TO OPERATION

1. Power source
Ensure that the power source to be utilized conforms
to the power source requirements specifi ed on the
product nameplate.
2. Power switch
Ensure that the switch is in the OFF position. If the
plug is connected to a receptacle while the switch is
in the ON position, the power tool will start operating
immediately and can cause serious injury.
3. Extension cord
When the work area is far away from the power
source, use an extension cord of suffi cient thickness
and rated capacity. The extension cord should be
kept as short as practicable.
WARNING
Damaged cord must be replaced
or repaired.
Lever
Guide roller
Fig. 2-І
8

ASSEMBLY AND OPERATION

Blade
holder
4. Check the receptacle
If the receptacle only loosely accepts the plug, the
receptacle must be repaired. Contact a licensed
electrician to make appropriate repairs.
If such a fautly receptacle is used, it may cause
overheating, resulting in a serious hazard.
5. Confi rming condition of the environment:
Confi rm that the work site is placed under appropriate
conditions conforming to prescribed precautions.
6. Changing blades
CAUTION
● Be sure to switch power OFF and disconnect the
plug from the receptacle when changing blades.
● Do not touch the lever when plunger is moving.
● Never touch the blade immediately after use.
The metal is hot and can easily burn your skin.
(1) Pull the lever in the direction indicated by the arrow.
(Fig. 2-І)
(2) With the lever pulled, insert the blade until it butts
against the outlet of the blade holder tip. (Fig. 2-ІІ)
(3) Release the lever. (Fig. 2-ІІІ)
Blade
Fig. 2-ІІ
Fig. 2
Plunger
Blade
Guide
holder
roller
Fig. 2-ІІІ