Metabo HPT CJ 14DSL Instructions De Sécurité Et Mode D'emploi page 14

English
Lever
Chip cover
Insert
Open
10. Sub base (Sold separately)
Using the sub base (made from steel) will reduce
abrasion of aluminium base especially in cutting
metals.
Using the sub base (made from resin) will reduce
scratching of cut surface. Attach the sub base to the
bottom surface of base by attached 4 screws.
11. About Remaining Battery Indicator
When pressing the remaining battery indicator switch,
the remaining battery indicator lamp lights and the
battery remaining power can be checked. (Fig.15)
When releasing your fi nger from the remaining battery
indicator switch, the remaining battery indicator lamp
goes off . The table 5 shows the state of remaining
battery indicator lamp and the battery remaining
power.
State of lamp
Battery Remaining Power
The battery remaining power is
enough.
The battery remaining power
is a half.
The battery remaining power is
nearly empty.
Re-charge the battery soonest
possible.
As the remaining battery indicator shows somewhat
diff erently depending on ambient temperature and
battery characteristics, read it as a reference.
14
Base
Fig. 13
Open
Chip cover
Fig. 14
Table 5
NOTE
○ Do not give a strong shock to the switch panel or
break it. It may lead to a trouble.
○ To save the battery power consumption, the
remaining battery indicator lamp lights while pressing
the remaining battery indicator switch.
CUTTING
CAUTION: on lithium-ion battery
To extend the lifetime, the lithium-ion battery
equips with the protection function to stop the
output. Therefore, if the tool is overloaded, the
motor may stop. However, this is not the trouble
but the result of protection function. In this case,
release the switch of tool and eliminate the
causes of overloading.
CAUTION
○ In order to prevent blade dislodging, damage or
excessive wear on the Plunger, please make sure
to have surface of the base plate attached to the
work piece while sawing.
○ At low speed do not cut a wood with a thickness
of more than 3/8" (10 mm) or metal with a
thickness of more than 1/32" (1 mm).
1. Rectilinear cutting
When cutting on a straight line, fi rst draw a marking
gauge line and advance the saw along that line. Using
the guide (sold separately) will make it possible to cut
accurately on a straight line.
(1) Loosen the base bolt by allen wrench attached on
base. (Fig. 16)
(2) Move the base fully forward (Fig. 17), and tighten the
base bolt again.
(3) Attach the guide by passing it through the attachment
hole on the base and tighten the M5 bolt. (Fig. 18)
(4) Set the orbital position to "0".
NOTE
To ensure accurate cutting when using the guide (Fig.
18), always set the orbital position to "0".
Remaining battery
indicator lamp
Remaining battery
indicator switch
Fig. 15