Assembly And Operation; Applications; Prior To Operation - Metabo HPT CJ 160V Instructions De Sécurité Et Mode D'emploi

ASSEMBLY AND OPERATION

APPLICATIONS

○ Cutting various lumber and pocket cutting
○ Cutting mild steel plate, aluminum plate, and copper plate
○ Cutting plastics, such as phenol resin and vinyl chloride
○ Cutting thin and soft construction materials
○ Cutting stainless steel plate (With No. 97 blade)

PRIOR TO OPERATION

1. Power source
Ensure that the power source to be utilized conforms to the power source requirements
specifi ed on the product nameplate.
2. Power switch
Ensure that the switch is in the OFF position. If the plug is connected to a receptacle while
the switch is in the ON position, the power tool will start operating immediately and can cause
serious injury.
3. Extension cord
When the work area is far away from the power source, use an extension cord of suffi cient
thickness and rated capacity. The extension cord should be kept as short as practicable.
4. Check the receptacle
Check the receptacle
If the receptacle only loosely accepts the plug, the receptacle must be repaired. Contact a
licensed electrician to make appropriate repairs.
If such a fautly receptacle is used, it may cause overheating, resulting in a serious hazard.
5. Confi rming condition of the environment:
Confi rm that the work site is placed under appropriate conditions conforming to prescribed
precautions.
WARNING
Damaged cord must be replaced or repaired.
English
7