Occasionally, a problem is minor and a service call may not be necessary - use this trouble shooting
guide for a possible solution. If the unit continues to operate improperly, call an authorized service
depot or toll free at 1-844-455-6097
Problem
No Power
Cabinet Temperature
too High
Alarm Beeping and "HI"
is displayed on the
control panel
Alarm Beeping and "LO"
is displayed on the
control panel
Condensation on the
cabinet and/or doors
Trouble Shooting
Possible Cause
A fuse in your home may
blown or the circuit
breaker
tripped
Power surge
Plug not fully inserted into wall
outlet
Temperature
not as set
Door(s) not shut properly
opened excessively
Exhaust vent is obstructed
Recently added a large
quantity of warm bottles
to the cabinet
Recently added a large
quantity of warm bottles to
the cabinet
The door is not closed tightly
System leak, evaporator fan
failure, compressor fan failure
Sensor Failure, evaporator
temperature is too low
High humidity conditions
in the home
Door(s) not shut properly
or opened excessively
11
What to do
be
Replace fuse or reset circuit breaker.
Unplug the wine cooler, wait a few
seconds and then plug it back in
Make sure the 3-prong plug on the
wine cooler is fully inserted into the
outlet
Verify the temperature control setting
Adjust if neccessary
or
Ensure that the doors are fully closed
and that the gaskets are sealing
against the cabinet. Open the doors
only as needed and for short periods
of time
Verify there is nothing blocking the
front mounted exhausting vent
Limit the quantity of warm items
being introduced to the cabinet.
Limit the quantity
being introduced to the cabinet.
Be sure the door is closed tightly
Contact service center.
To stop beeping, unplug the unit
Contact service center.
To stop beeping, unplug the unit
The condensation will subside once
humidity conditions return to normal
Ensure that the doors are fully closed
and that the gaskets are sealing
against the cabinets. Open the doors
only as needed and for short periods
of time
of
warm items