Trouble Shooting; Before Your Call For Service - Danby Silhouette DWC2121BLS Guide Du Propriétaire

Before You Call For Service
Problem
No Power.
Cabinet Temperature
too High
"Clicking" Noise
Condensation on the
cabinet and/or doors
If none of the above rectify the situation please contact our customer care department
at 1-800-26-

Trouble Shooting

Possible Cause What to do
A fuse in your home may
be blown or the circuit
breaker tripped.
Power surge.
Plug not fully inserted into
wall outlet
Temperature setting
Door(s) not shut properly
or opened excessively
Exhaust vent is obstructed
Recently added a large
quantity of warm bottles
to the cabinet
Normal sound
High humidity conditions
in the home.
Door(s) not shut properly
or opened excessively
(1-800-263-2629)
10
Replace fuse or reset circuit breaker.
Unplug the wine cooler, wait a few
seconds and then plug it back in.
Make sure the 3-prong plug on the
wine cooler is fully inserted into outlet.
Verify the temperature control setting.
adjust if neccessary.
Ensure that the doors are fully closed
and that the gaskets are sealing,
against the cabinets. Open the doors
only as needed and for short periods
of time.
Verify there is nothing blocking the
front mounted exhausting vent.
Limit the quantity of warm bottles
being introduced to the cabinet at the
same time. Attempt to phase in the
load introduction if possible. (i.e. load
no more than 6 warm bottles at once-
3 per compartment)
No user intervention is required as
this sound is normal during the opera
tion of the appliance. This audible
'clicking' noise may be heard as the
wine cooler ends or begins a cooling
cycle.
The condensation will subside once
humidity conditions return to normal.
Ensure that the doors are fully closed
and that the gaskets are sealing.
against the cabinets. Open the doors
only as needed and for short periods
of time.