Signature SHD60FLIGNE/2 Manuel D'utilisation page 29

Repeat this operation on the other side, checking that the
two marks are on the same horizontal line.
Mark a point (3) on the horizontal line C, 100 mm to the
vertical reference line . Repeat this operation on the other
side , checking that the two marks are leveled.
Fix the brackets :
Drill holes at the marked points with a
Insert the Wall Plugs 11 into the holes.
Fix the hood fixing bracket 20 with 3 screws 10 (5 x 50) at
the horizontal line A.
Fix a Chimney fixing bracket 21 with 2 screws 10 (5 x 50)
at the horizontal line B.
Lower decorative chimney
Fix the exhaust pipe on the hood
body,connect chimney and hood
body with 2 screws 12. connect
chimney fixing bracket and chimney
with 2 screws 12.
Hook the hood body
Hook the hood body to the bracket 20.
Level the hood body itself.
Remove the filter from the inside of the hood body, fix
the screws 10 to Wall Plugs 11 at the points (3).
Right
ɸ
Wrong
9
10 mm drill bit.