Nmea Operation; Nmea Input; Nmea Output - Uniden UM425 Guide D'utilisation

Specifications

NMEA Operation

This radio supports NMEA0183 version 3.01.

NMEA Input

If you have difficulty getting the UM425 to receive data from your GPS receiver,
check the device's configuration. It should be set to the parameters shown in
Table 16.
Table 16 - NMEA Input Parameters
Baud rate
Data bits
Parity
Stop bits
Data amplitude
Drive capability
• Status:RMC > GLL > GNS > GGA
• Latitude/Longitude:RMC > GLL > GNS > GGA
• UTC Time: RMC > GLL > GNS > GGA > ZDA
• Date: RMC > ZDA
• Speed / Course:RMC
NOTES :
• If the radio receives only a GLL sentence, the radio does not display the
current speed, course, and date.
• If the radio receives both RMC and GLL sentences, the radio uses only
the RMC sentence.
• Status data is used to check whether the GPS data is valid or invalid.

NMEA Output

When the radio receives a DSC call (Distress, Position Reply, or Position
Send), it outputs a DSC/DSE sentence from the NMEA output port. NOTE:
When the radio receives a distress call, it outputs a sentence in the following
format.
• $CDDSC,12,3081234000,,07,00,0354013946,0657,,,S,E*6D
• $CDDSE,1,1,A,3081234000,00,60875646*13
4800 bps
8
None
1
Over 3.0 V
Over 10 mA
E-67
The radio supports RMC, GLL, GNS,
GGA and ZDA sentences. When
these sentences are received, the
radio displays latitude/longitude,
date, time, course, and speed. If
any sentence except an RMC or
GLL sentence is received, the radio
uses the information based on the
following priority order.