Remote Communication; Remote Communication Via External Modem - Ingeteam INGEREV Manuel D'installation Et Usage

INGEREV GARAGE Wall

3.3. Remote communication

3.3.1. Remote communication via external modem

1. Connect the communications card with Ethernet connection to one of the charging stations located at one
end of the installation. This station will act as the first in the communication ring. It can be connected
both with the J15 and J17 connectors, as well as the J16 and J18 connectors.
In this station, remove the end of line jumper from the control card (marked as A in the following figure)
and connect the charging station to the next station of the communication ring (dark gray cable in the
figure below).
A
2. Connect the wiring that joins the control card to the communications card (see the dark gray cable in the
following figure).
Connect the modem to the communications card (see the white cable in the figure below).
ABA2017IQM01_B - Installation and Operation Manual
Pin Color
1 White/Orange
2 Orange
Signal
RS-485 B (+)
RS-485 A (–)
Ingeteam
EN
ES
FR
IT
11