Ingeteam INGEREV Manuel D'installation Et Usage page 25

INGEREV CITY Duo
5. Connect the wiring that joins the control card to the communications card (see Cable E, light gray cabling
in the following figure). Then connect the cable that joins the communications card with the USB modem
(F).
To wire the communications card and control card at the station, you must keep in mind the following
connection positions:
The communications card switch (marked as G in the above figure) must have position 3 On.
5. Connect the charging stations that make up the communication ring from the back, as indicated in the
following figures.
First station
ABA2017IQM01_B - Installation and Operation Manual
E
Pin Color
1 White/Orange
2 Orange
Intermediate station
F
Signal
RS-485 B (+)
RS-485 A (–)
Ingeteam
G
Final station
25
EN
ES
FR
IT