Steelcase Série 2 Guide D'utilisation page 4

Steelcase Series 2 Controls (EN)
WARRANTY
The Steelcase Series 2 chair is tested to 400 lbs (180 kg) and meets ANSI BIFMA requirements.
The Steelcase Warranty applies to multi-shift use. Any servicing of your Steelcase Series 2 chair
must be performed by an authorized Steelcase dealer.
HEIGHT-ADJUSTABLE LUMBAR
For additional back support, grasp both handles and
slide up or down. Position the lumbar to fit comfortably
into the curve of your lower back.
HEIGHT/WIDTH/PIVOT/DEPTH ADJUSTABLE ARMS
Lift button under arm caps to adjust height. To adjust
arm cap position, grasp arm caps and slide in any
direction. Keep your elbows close to your sides, with
your wrists straight.
BACK TENSION AND BACK ANGLE
Turn the dial to one of the three comfort settings:
Upright back lock
•
Full recline with weight-activated tension + boost
•
Full recline with weight-activated tension
•
SEAT HEIGHT
To raise chair, lift your body weight and hold lever up.
To lower chair, remain seated and hold lever up.
SEAT DEPTH
Pull handle and hold, slide seat forward or back, and
release lever to lock. With your back against the chair,
you should have 2" – 3" of space between the backs
of your knees and the seat edge.
Tip: lift weight out of seat when adjusting depth.