Husqvarna 545RXT AutoTune Manuel D'utilisation page 11

2. Put the throttle handle onto the right side of the
handlebar.
3. Align the screw hole in the throttle handle with the
hole in the handlebar.
4. Put the screw into the hole at the bottom of the
throttle handle, through the handlebar.
5. Put back and tighten the nut.
To assemble the handlebar
1. Remove the knob and attach the handlebar as given
in the illustration.
2. Tighten the knob lightly.
3. Put on the harness and hang the product from the
suspension point.
4. Adjust the handle to put the product in a comfortable
work position.
5. Tighten the knob fully.
171 - 008 - 08.06.2020
To set the handlebar in transport
position
1. Loosen the knob.
2. Turn the handlebar clockwise until the throttle handle
touches the battery.
3. Turn the handlebar around the shaft.
4. Tighten the knob.
To assemble the cutting equipment
The cutting equipment includes a cutting attachment and
a cutting attachment guard.
WARNING: Use protective gloves.
WARNING: Always use the cutting
attachment guard that is recommended for
the cutting attachment. See
page 28 .
WARNING: An incorrectly attached cutting
attachment can result in injury or death.
To attach and remove the guard extension
The guard extension is used on the combination guard.
Attach the guard extension when you use a trimmer
head or plastic blades. Remove the extension guard
when you use a grass blade.
1. Put the guide on the guard extension into the slot on
the combination guard. Click the 4 locking hooks into
position.
Accessories on
11