TESTO 104-IR BT Mode D'emploi page 15

Setting the emission level:
· When IR measurement is enabled, press and hold down[
] and [ ] at the same time (
· Emission level is displayed.
· Use [ ] or [
Contact measurement
- Instrument is switched on, contact measurement is enabled
( lights up), Bluetooth
1 Position the contact thermometer in the measurement
object and initiate the measurement: press [
2 End measurement: press [
- Hold lights up. The last measuring value and min./max.
value are saved until the next measurement, or until the
instrument is switched off.
AutoHold function: if this function is enabled, the
measurement is ended automatically as soon as the
measuring value is stable, AutoHold lights up.
Switch between min., max. and recorded value:
press [ ].
The min./max. values can be reset:
· switch the instrument off, switch to IR measurement or,
while the held measuring value is displayed (Hold lights
up), press and hold down [
Restart measurement: press [
8. Settings
- The instrument is switched off.
If no button is pressed for 3 s in settings mode, the
instrument switches to the next view.
1 Press and hold down [
flashes.
2 Switch the AutoHold function on (AutoHold) or off (Hold):
press [ ] or [
- °C, °F or °R flashes.
3 Set measurement unit to degrees Celsius (°C), degrees
Fahrenheit (°F) or degrees Réaumur (°R): press [
- flashes.
4 Switch the laser on (on) or off (oFF): press [
5 Switch Bluetooth
- The instrument switches to IR measurement.
®
- Bluetooth
terminals with a Bluetooth
is established, a beep is emitted and the Bluetooth
shown in the display.
] to change the value and wait for 3 s.
] and [
].
®
on (on) or off (oFF): press [
is enabled and can be detected by mobile Testo
®
lights up).
®
mode is enabled.
].
] until Clr lights up.
].
] until AutoHold or Hold
interface. When the connection
].
] or [ ].
] or [ ].
] or [ ].
®
icon is
15