LaserLiner DampFinder Compact Plus Mode D'emploi page 15

7
Index mode (Determine building moisture)
The universal index mode is used to compare measuring points
and therefore to ascertain moisture. The moisture content of
building materials can be additionally determined in % with the
aid of the conversion table.
If there is no response when measuring, it is possible
!
that the measured material is too dry. Perform a self-test
of the device with the protective cap to make sure the
device is in good working order.
8
Unit of temperature selection °C / °F
(see fig. C, page 02)
9
Auto-Hold function
The last measurement value will continue to display for about
5 seconds after removing the device from the measured material.
The symbol of the selected mode flashes and the measured
value last determined is displayed. The device is ready for a new
measurement as soon as the flashing stops and the measured
value is reset to 0.
DampFinder Compact Plus
Be aware that walls (or surfaces)
with differing material structures,
or even variations in material
composition, can cause measure-
ment results to be falsified. Perform
multiple comparative measurements.
You read off the measurement
results from the following index
scale and convert them to %
with the aid of the table.
Example
Building material: anhydrite screed
Measured value: 265
Result: 0.1% material moisture
15
EN