IFM Electronic Efector 400 RO6341 Notice De Montage page 9

Open to one side
hollow shaft
1. Place the clamping nut on the encoder.
2. Slip the encoder onto the shaft (min. 10 mm) and fix the stator
coupling by means of four M3 screws.
3. Tighten the screws of the clamping nut.
Linear movements can be transformed into a rotational movement
using a measuring wheel or rack and pinion. For mounting the maxi-
mum permissible shaft loads of the encoder must be taken into
account.
The data sheet, further documents and suitable accessories are avail-
able on our website at www.ifm.com.
stator coupling
Wellenklemmring
9