Turning On The Power And Registering The Cameras - Sony NSR-S10 Manuel D'utilisation

Turning on the power and registering
the cameras
After turning on the NSR, you can begin monitoring immediately if you register the cameras
automatically.
Note
The power comes on automatically when the power cord of the AC adapter is plugged into
the power outlet. After the NSR has been turned off either by a screen-based operation or by
the power switch on the rear panel, the power can be turned back on by pressing the power
switch.
1
Plug the power cord of the AC adapter into the power outlet.
The unit beeps, and the POWER LED on the front panel lights green.
After a minute or two, the message "System Starting, Please Wait..." appears on the
monitor.
The "Authorization" screen appears after the unit starts up.
2
Enter the user ID and password, and click [OK].
If no keyboard has been connected to the unit, click
keyboard. Use the soft keyboard to enter the user ID and password.
Note
The default user ID and password are as follows.
Default user ID: admin
Default password: admin
18

Turning on the power and registering the cameras

(keyboard) to display the soft