Marmitek MT10 BEDROOM Mode D'emploi page 4

HouseCode as the timer (modules 1 through 16).
SWITCH OFF ALL MODULES
You can also switch off all Marmitek X-10 modules with one press of a button. To do this,
press "ALL UNITS OFF" [6].
3. PROGRAMMING ACTIONS
You can pre-program actions for 4 different (groups of) modules. You can select modules 1
through 4 or 5 through 8. You can select the modules by setting the selector to 1-4 or 5-8 [10].
HOW TO PROGRAM:
1. Set the mode selector to "PROG. SET" [1].
2. Set the unit selector to UnitCode 1-4 or 5-8 [10].
3. Set the time using the <TIME> buttons.
ATTENTION: make sure that for actions taking place in the morning, the "PM" LED is
switched off [13]. With actions that take place in the afternoon, the "PM" LED should be lit.
4. Press ON for the module you want to activate at the selected time [4]. If you want to
switch off a module at the selected time, press OFF [4].
Repeat steps 3 and 4 for the next action you want to pre-program.
P.S. If you want to program more than two actions for the same module, the display will read
18:88. To reset the display, switch the mode selector to "PROG. REVIEW" [1] and press the
OFF button [4] of the module you were programming. Follow the instructions under
"Clearing actions" to make room for the action you want to program. When you are finished
programming the times, switch the selector back to "RUN".
VIEWING PROGRAMMED ACTIONS
Switch the mode selector to "PROG. REVIEW". Press the ON or OFF side of the switch of the
module you want to view the actions for. Press the ON or OFF side twice to also see the
second programmed time.
CLEARING ACTIONS
You can clear every pre-programmed action separately. First view the programmed actions
and press "CLEAR" [11] if you want to erase the time indicated.
NON-RECURRENT ACTIONS
If you want to program an action that should be executed only once, press the "ONCE"
button [8] within 4 seconds of programming the action and pressing the ON or OFF button.
4 MARMITEK