Table des Matières
Publicité
7. PROBLEMS
Some possible problems wich may arise while using the lift are listed below. Ravaglioli will not accept any resposibility
for damage people, animals and objects caused by unautorized staff using the equipment. In the event of faults, you are
advised to contact the technical service department in good time to receive advice about how to carry out work and/or
adjustments in maximum safety conditions, thus avoiding the risk of damage to people, animals and objects.
Turn the main switch to "0" and lock in case of emergency and/or maintenance to the lift.
TROUBLE
The pump has little
a)
pressure, it works
irregularly and
b)
sprung-like and is
noisy
c)
The basket does
a)
not turn
b)
c)
d)
e)
Water comes out of
a)
the driving shaft
Foam presence in
a)
the bath
b)
c)
Burning of contacts
a)
or internal wires.
do not attempt to do the job yourself
POSSIBLE CAUSES
Filters are too dirty
Liquid level is too low
Clogged nozzles
Weight is too much unbalanced
Basket is too much loaded
No grease in the bearings
Grease clogging the basket or the
runner.
Failure of gearmotor thermic
The liquid level exceeds the driving
shaft.
Bath temperature is too low
Different and not compatible
detergents have been mixed.
Bath is very dirty and tends to
saponify, thus creating foam.
Electric absorbance of resistance and
working vibrations can loosen the
clamps of some wires inside the
electric system and cause imperfect
contacts.
1762-M001-0
TECNICAL SERVICE REQUIRED
a)
Dismount and clean
b)
Restore or replace the liquid if too dirty.
c)
Dismount and clean
a)
Place the parts of the basket in a better
way
b)
Make the weight lighter
c)
Dismount and grease
d)
Dismount and clean
e)
Restore a thermic efficienc
a)
Restore the liquid level.
a)
Check that the thermostat is set to 60°C
(never increase the temperature over this
threshold).
Replace all the liquid.
b)
c)
Replace all the liquid.
a)
It is sufficient to restore the perfect
blocking of the clamp.
REMEDIES
7
43
Publicité
Table des Matières
