WAGNER W 2400 Mode D'emploi page 11

W 2400
Unsuitable coating materials
Paints containing solvents, silicate paints and lime paints.
Preparation (Figures 1, 3, 4)
Figure 2)
( = Extra: power pack
Remove upper part of device (Figure 5)
•
Hold tank tight
•
Swivel upper part of device 90° (quarter turn) counter-clockwise
and lift off
Commissioning
Preparation of the paint:
•
Dilute paint with approx. 10 % water and mix well.
•
Fill with paint
Mounting upper part of device:
•
Mount upper part of device at 90° (quarter turn) to tank. Swivel
upper part of device clockwise over the tank until you can feel it
lock in place (Figure 5)
Switch on pump (Figure 6):
Position I:
Position II:
•
As soon as the paint has reached the paint cylinder, begin rolling
(Figure 7)
•
Roll with even movements and ensure good paint distribution
Work interruptions
Short interruptions:
•
Switch off pump
•
Do not set paint roller down lower than the device
run out
Work interruptions of up to one day:
•
Switch off pump
•
Place paint roller immediately in a plastic bag and seal air-tight
(Figure 8)
•
Do not set paint cylinder down lower than device
small pumping quantity
large pumping quantity
GB
paint could
7