Before You Begin - Kreg Accu-Cut XL Guide D'utilisation

ATTENTION
The Accu-Cut
portable circular saws that have a metal upper blade guard. When
paired with the Accu-Cut XL, a saw with a plastic upper blade guard
™
may allow deflection between the blade and the base plate resulting
in poor cut quality. Do not use a saw with a plastic upper blade guard
with the Accu-Cut XL.
™
Preparation (Accu-Cut
Step 1: Remove the set screws and aluminum connector bars from your Accu-Cut
(KMA2700) tracks. Discard the screws and bars. (Replacement connector bars are
steel and provide proper support for the weight and length of the expansion track.)
Step 2: Remove the starting block from the track. Remove and discard all four guide strips.
Remove guide-strip adhesive residue from the tracks with a label-adhesive remover
(available at home centers and hardware stores).
Step 3: Follow the Track Assembly instructions below.
Track Assembly (Accu-Cut
Assemble the Track
1
Arrange two track sections (A) on your
work surface with the Accu-Cut
at the ends and the arrow heads at center
pointing toward each other.
Keeping the tracks in the above orientation,
turn them upside down. Slide connector bars
(C) halfway into the T-slots in one track and
thread in and tighten the set screws (D).
ATTENTION
Do not overtighten the set screws. Overtightening
can cam-out the screw heads or damage the aluminum track.
Slide the second track onto the protruding
connector bars. Align the tracks with a
straight edge (48" level shown), tightly hold
together the two tracks, and thread in and
tighten the remaining set screws. Repeat
this process with the remaining two track
sections. You now have two track pairs.

Before you begin

XL is designed for use with
™
logos
™
Expansion Pack only)
™
XL and Accu-Cut
™
A
Expansion Pack)
™
Arrows
Logos
C
D
D
C
Upper blade guard
™
A
Straight edge