HQ Power VDSMB17 Mode D'emploi page 4

4. Installation
V. 02 – 28/09/2016
VDSMB17/VDSMB17S
Use the enclosed template to mark out the cut
out. Then, simply cut along the line.
Installation dimensions: Ø 210 mm.
Installation depth: > 94 mm.
When laying the loudspeaker cable (not included)
from the amplifier to the installation point, be
sure that the cable neds about 30 cm (12")
beyond the wall cut out.
Connect the speaker cable to the screw clamps.
Ensure that the polarity is correct.
Tighten the clamp screws until you can feel the
frame, press firmly against the wall. This
indicates that the clamp* is extended and is
gripping the wall.
4 ©Velleman nv