Leds On Battery; Assembling The Trimmer; Mounting The Bump Guard; Mounting The Guard - Stihl FSA 86 R Notice D'emploi

English
6.3

LEDs on Battery

The LEDs can show the state of charge or malfunctions. The
LEDs can glow or flash green or red.
The state of charge is indicated when the LEDs glow or flash
green.
► If the LEDs glow or flash red: Troubleshooting, @ 18.
Malfunction in trimmer or battery.

7 Assembling the Trimmer

7.1

Mounting the bump guard

► Switch off the brushcutter and remove the battery.
► Insert the ends of the bump guard (1) into the holes (2) in
the housing.
The bump guard (1) need not be removed.
7.2

Mounting the guard

► Switch off the brushcutter and remove the battery.
36
2
2
1
1
2
The line limiting blade (1) has already been installed in the
guard (2) and must not be removed.
► Push the guard (2) into the guides on the housing until it
hits the limit stop.
The guard (2) is flush with the housing.
► Insert and tighten down the screws (3).
The guard (2) must not be removed.
7.3

Mounting the Loop Handle

► Switch off the brushcutter and remove the battery.
1
2
6
7
► Fit the clamp (4) in the loop handle (3).
► Place the loop handle (3) with clamp (4) on the shaft (5).
► Fit the washers (2) on the screws (1).
► Press the clamp (6) against the shaft (5).
► Insert the screws (1) through holes in the loop handle (3)
and clamps (4 and 6).
7 Assembling the Trimmer
3
2
3
4
5
0458-833-9621-A