KNF N87.9 EX Traduction Du Mode D'emploi Original page 49

Table des Matières

Publicité

Certificate No.:
IECEx EUT 14.0001X
Date of issue:
2021-06-29
Manufacturer:
ORANGE1 ELECTRIC MOTORS S.p.A.
Via Mantova, 93
43122 Parma
Italy
Additional
manufacturing
locations:
This certificate is issued as verification that a sample(s), representative of production, was assessed and tested and found to comply with the
IEC Standard list below and that the manufacturer's quality system, relating to the Ex products covered by this certificate, was assessed and
found to comply with the IECEx Quality system requirements.This certificate is granted subject to the conditions as set out in IECEx Scheme
Rules, IECEx 02 and Operational Documents as amended
STANDARDS :
The equipment and any acceptable variations to it specified in the schedule of this certificate and the identified documents, was found
to comply with the following standards
IEC 60079-0:2017
Explosive atmospheres - Part 0: Equipment - General requirements
Edition:7.0
IEC 60079-1:2014-06
Explosive atmospheres - Part 1: Equipment protection by flameproof enclosures "d"
Edition:7.0
IEC 60079-31:2013
Explosive atmospheres - Part 31: Equipment dust ignition protection by enclosure "t"
Edition:2
IEC 60079-7:2015
Explosive atmospheres – Part 7: Equipment protection by increased safety ''e''
Edition:5.0
This Certificate does not indicate compliance with safety and performance requirements
TEST & ASSESSMENT REPORTS:
A sample(s) of the equipment listed has successfully met the examination and test requirements as recorded in:
Test Report:
IT/EUT/ExTR14.0001/03
Quality Assessment Report:
IT/EUT/QAR14.0001/09
IECEx Certificate
of Conformity
other than those expressly included in the Standards listed above.
Page 2 of 4
Issue No: 3

Publicité

Table des Matières
loading

Table des Matières