On-Unit Indicators And Controls - Airwell WMN4 Instructions D'emploi

ON-UNIT INDICATORS AND CONTROLS

ON-UNIT OPERATION
If the air-conditioner cannot be operated by the Remote Control unit, it
can be turned on for cooling or heating, or completely turned off, by
pressing MODE button (F) on the air-conditioner. The MODE button will
change the operating status of the unit between - COOLING - HEATING
- STAND-BY positions, every time it is pressed. Indicators (E), (G) or
(A) will light up respectively, to indicate in which mode the air-conditioner
operates.
On units for Cooling only, do not set MODE switch on HEAT position.
AUTO-HORIZONTAL AIR MOVEMENT (J)
For Auto movement turn switch (J) to position (1)
For desired air blades positioning turn switch momenterily to position
(2) and then to (3).
Note: in some models this function is manual
4
STAND-BY
A
INDICATOR
Lights up when the air
conditioner is connected
to power and ready to
receive the remote control
commands.
OPERATION
B
INDICATOR
Lights up during
operation. Blinks once to
announce that the remote
control infrared signal has
been received and stored.
Blinks continuously in
protection mode.
TIMER INDICATOR
C
Lights up during timer
and sleep operation.
D FILTER INDICATOR
Lights up when air filter
requires cleaning.
COOLING INDICATOR
E
Lights up only when
Mode (F) is pressed.
COOL / HEAT / OFF /
F
ON UNIT OPERATION
Lift up
BUTTON
the units
display
Used to switch the unit
cover to
OFF or to turn it ON for
reach
COOLING or HEATING
the on
without the use of the
unit
control
remote control.
HEATING
G
INDICATOR
Lights up only when
Mode (F) is pressed.
H
RESET BUTTON
Press to turn off the
G
FILTER indicator and to
reset the filter function,
after the clean filter has
been reinstalled.
Press to cancel the
G
buzzer announcer, if
elected.
SIGNAL RECEIVER
I
Receive signals from
G
the remote control.
Horizontal air
J
movement switch.