MODES OF OPERATION, FUNCTIONS
AND FEATURES
In HEATING , the fan will be turned off when the compressor is not in operation
and will not be restarted, unless the indoor coil reaches adequate temperature.
HOT KEEP
This HOT KEEP feature prevents uncomfortable cold air drafts. In some models
the HOT KEEP function is operating in AUTO FAN mode only.
The air flap (louver) is automatically positioned for the most suitable blow-out
angle, when COOL, HEAT, DRY or FAN modes are selected. When the air
AUTO FLAP
conditioner is turned off, the flap will close automatically for an aesthetic
appearance.
Filter indicator on the indoor unit display is turned on when the filter requires
FILTER
INDICATION
cleaning. After cleaning and reinstalling the filter, the system should be reset.
A soft buzzer will sound from the indoor unit display to indicate that a command
sent by the remote control has been accepted and stored in the unit's memory.
BUZZER
This feature may be easily canceled by the user from the display panel.
The air conditioner can be turned ON for COOLING or HEATING or be turned
ON UNIT
OFF directly from the indoor unit display panel without the use of the remote
OPERATION
control.
3-MIN.
The compressor is protected by a three-minute delayed restart.
DELAYED RUN
The microprocessor retains the last data entry whether or not the unit is plugged
MEMORY
in. Therefore, when the unit restarts after a power distruption or failure, it will
resume operating in the same mode as before the power was disrupted.
3