Unpair; Pairing The Wireless Flush-Mount Shutter Actuator With The Brematicpro Gateway; Factory Reset - brennenstuhl BrematicPRO UPRS 868 01 W300 3726 Mode D'emploi

Unpair

Press and hold the pair button for 3 to max. 5 seconds. The LED
will flash red.
Whilst the LED is flashing, press a
button on the left of the BrematicPRO
wireless remote control you wish
to program for the device.
Once the devices have been paired
the LED will got out.
This completes the pairing process.
You can now open or close shutters.
The right button features the
"DOWN" function and the left
button features the "UP" function.
You must hold the respective
button pressed while doing so.
Whilst the LED is flashing, press
the respective button on the right
of the BrematicPRO wireless
remote control you wish to unpair.
This completes the unpairing
process.
Wireless flush-mount shutter actuator 868.3 MHz
Pairing the wireless flush-mount shutter
actuator with the BrematicPRO Gateway
When linked with the Home Automation Systems BrematicPRO via
the BrematicPRO Gateway, you can use the app / BrematicPRO PC
software to use additional functions, e.g. timer control, theme control,
astro function (dawn/dusk control).
The app or BrematicPRO PC software is installed and open.
The BrematicPRO Gateway is ready for use.
Keep the device at least 50 cm from the Gateway.
Open the "Settings" menu.
Select the room where you wish to use the device.
Select "Add Device".
Select the frequency "868 MHz".
Under "New Device", select "Shutter" and click "Continue" to
confirm your selection.
Follow the on-screen instructions.
Press and hold the pair button on the device for 3 seconds.
Once both devices have been paired, the LED will firstly flash
red and then go out.
Enter a device name, e.g. "Living Room Shutter".
Select "Add" to assign the device to the room.
First tap "Back" to leave the room, then "Done" to complete the
pairing process.
The wireless flush-mount shutter actuator is now connected to
the Home Automation Systems BrematicPRO.
Use "Test Device" to execute the functions "Up / Stop / Down"
to ensure the wireless flush-mount shutter actuator is working
properly.
In this submenu you can also add the device to your favourites.
Note: If you would like to open or close the shutters by pressing a
button once, a task must be defined (via BrematicPRO Gateway
and the App).
For more information about the app and how to use it, please visit:
www.brematic.com/en/service.

Factory Reset

The device can be restored to the factory settings at any time. A reset
will be required if malfunctions occur.
Press the pair button for at least 6 seconds.
The LED will flash rapidly and go out after approx. 3 seconds.
The device has been reset.
EN 13