Adjustments; Replacing Parts - Ndustrio 0G1CP1EC Manuel D'utilisation Et D'installation

TESTING OF THE APPLIANCE
Important
Before it is put into service, the system
must be tested to check the operating con-
ditions of every single component and iden-
tify any malfunctions. In this stage, it is
important to check that all health and safety
requirements have been complied with in
full.
To test the system, make the following checks.
1 - Turn on the water supply tap and make sure that
ADJUSTMENTS PROCEDURE
The appliance's main functions do not require
any special adjustments by specialist staff ex-
IT
REPLACE PROCEDURE
The appliance does not require the replacement of
GB
operating components by specialist staff except the
DE
DECOMMISSIONING THE APPLIANCE
FR Important
This operation must be carried out by
skilled operatives in compliance with the le-
ES
gal requirements with regard to safety at
work. Never dump non-biodegradable mate-
English

ADJUSTMENTS

REPLACING PARTS

- 16 -
the connection is watertight.
2 - Check that the mains voltage is the same as
that of the appliance.
3 - Operate the appliance's circuit-breaker to check
the electrical connection.
4 - Check that the safety device is operating cor-
rectly.
After testing, if necessary instruct the user in all the
skills necessary for putting the appliance into oper-
ation in conditions of safety, in accordance with le-
gal requirements.
cept the settings made during use by the user.
replacement of standard parts which can be carried
out by the user.
rials, lubricating oils and non-metallic com-
ponents (rubber, PVC, resins, etc.) in the
environment. Dispose of them in accord-
ance with the relevant legal requirements.
8
9